Configuring The Access Profile Table - D-Link DES-6500 - Switch User Manual

Due to a backward compatibility issue, when a user upgrades to R3 firmware (3.00-B33),
all settings previously configured for any ACL function (CPU ACL included) on the Switch
will be lost. We recommend that the user save a configuration file of current settings before
upgrading to R3 firmware.

Configuring the Access Profile Table

To display the currently configured Access Profiles on the Switch, open the Configuration folder and click on the Access Profile
Table link. This will open the Access Profile Table page, as shown below.
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile Configuration page, as
shown below. There are four Access Profile Configuration pages; one for Ethernet (or MAC address-based) profile
configuration, one for IP address-based profile configuration, one for the Packet Content Mask and one for IPv6. You can
switch between the three Access Profile Configuration pages by using the Type drop-down menu. The page shown below is the
Ethernet Access Profile Configuration page.
The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-8)
Type
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 54. Access Profile Table
Figure 6- 55. Access Profile Configuration (Ethernet)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 - 8.
Select profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
This will change the menu according to the requirements for the type of profile.
86