D-Link DES-6500 - Switch User Manual page 112

To configure the Access Rule for IPv6, open the Access Profile Table and click Modify for an IPv6 entry. This will open the
following screen:
Click Add to open the next screen to configure the IPv6 entry for an access rule.
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter
Profile ID
Mode
Access ID
Type
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Figure 6- 68. Access Rule Table
Figure 6- 69. Access Rule Configuration – IPv6
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access rule. This value can be set from 1 - 65535.
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
IPv6 instructs the Switch to examine the IPv6 part of each packet header.
•
97