D-Link DES-6500 - Switch User Manual page 294

DES-6500:4#show stack_information
Command: show stack_information
Box
ID Type
--- -----------
1 DES-6505
2 DES-6507
3 USR-NOT-CFG
4 DES-6508
5 DES-6508
6 DES-6507
7 DES-6504
8 USR-NOT-CFG
--------------------------------------------------------------------------------------------------
Topology
Current state :MASTER
Box Count
DES-6500:4#
Step 2
Upgrade the CPU firmware R3.00-B33, as shown below.
DES-6500:4#download firmware_fromTFTP 10.48.74.121 c:/6500rU_3.00-B33.had unit cpu
Command: download firmware_fromTFTP 10.48.74.121 c:/6500rU_3.00-B33.had unit cpu
Connecting to server..................................... Done.
Download firmware...................................... Done. Do not power off!
Please wait, programming flash....................Done.
Saving current settings to NV-RAM...............Done.
Please wait, the switch is rebooting...
Step 3
Once rebooted, check the "show switch" command to verify that the firmware was downloaded correctly. The user can then
upgrade the Runtime Version code for the inserted line cards using the following syntax in the CLI.
DES-6500:4#download firmware_fromTFTP 10.48.74.121 c:/6500rS_3.00-B33.had unit all_line_card
Command: download firmware_fromTFTP 10.48.74.121 c:/6500rS_3.00-B33.had unit all_line_card
Connecting to server................... Done.
Download firmware.................... Done.
Connecting to slave...................Done.
Upload firmware .......................Done.
Line card will automatically reboot after a few minutes. Please don't power off!
Success.
DES-6500:4#
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Prio- Prom
Exist rity
----- -----
exist 16
exist 16
no
exist 16
exist 16
exist 16
exist 16
no
:STAR
:6
Runtime
version version
-------- --------
0.00-B16 2.00-B20
0.00-B16 2.00-B20
1.50-B19 2.00-B20
1.50-B19 2.00-B20
1.50-B19 2.00-B20
2.00-B20 2.00-B20
279
H/W
version
--------
0A1
3A1
0A1
0A1
2A1
2A1