Table of Contents
Advertisement
5-18
Repair
Plastic Rail Removal
Use the following steps to remove the plastic rail from the system board:
Remove the system unit cover as previously described.
1.
2.
Remove the system board as previously described.
3.
Place the system board on a level static-free surface.
4.
Remove the two screws that hold the plastic rail to the underside of the system
board (see Figure 5-16).
Lift the system board off the plastic rail.
5.
Lift grounding clips off their notched seats on the plastic rail.
6.
Figure 5-16 Removing the System Board Plastic Rail
NOTE: The grounding clips are keyed to fit
correctly on the plastic rail. Make sure the clips
are fully seated on the plastic rail before
attaching the rails to a system board.
Advertisement
Table of Contents
Troubleshooting
