Table of Contents
Advertisement
3-40
Option Installation
Diskette Drive Installation
The diskette drive that comes with the system can be upgraded. Before adding a new
device, the installed diskette drive must be removed.
Removing a 3 1/2-Inch Diskette Drive
Use the following steps to remove the 3 1/2-inch diskette drive:
1.
Remove the system unit cover and front panel as previously described.
2.
Unplug the power cable and signal cables from the rear of the diskette drive.
3.
Remove the four screws holding the diskette drive to the wall of the chassis (see
Figure 3-34).
4.
Slide the diskette drive back about an inch to free it from the cutout in the front of
the chassis. Lift it out of its bracket in the chassis.
NOTE: When reinstalling the diskette drive,
note that all power cables are keyed to fit only in
the correct position.
Figure 3-34 Diskette Drive Screws
Advertisement
Table of Contents
Troubleshooting
