NEC PowerMate Enterprise Manual page 146

T
SCSI device (SCSI configured systems)
each SCSI device installed in the system:
Check the jumper settings on the device before installing it. Each SCSI device
must have a SCSI ID number set for the device. See "SCSISelect Utility" in
Section 2 of this manual for information on setting ID numbers. Also see
Appendix B, "Jumper Settings," and the device's documentation for
information on setting SCSI IDs.
The last SCSI device on an internal or external SCSI cable must be
terminated. See "SCSISelect Utility" in Section 2 of this manual and the
device's documentation for information on setting terminations.
The following table provides a chart for configuring IDE devices on the primary and
secondary IDE connectors on the riser board.
Configuration
1 device (hard disk
2 devices (hard disk,
CD-ROM)
2 devices ( hard disk,
tape backup unit)
2 devices ( hard disk,
Zip drive)
3 devices (hard disk,
CD-ROM, Zip drive)
3 devices (hard disk,
CD-ROM, tape backup unit)
3 devices (hard disk,
hard disk, CD-ROM)
3 devices (hard disk,
hard disk, tape backup unit)
3 devices (hard disk,
hard disk, Zip drive)
NOTE: You can install a maximum of three
devices in the desktop chassis.
Table 3-2 IDE Connector Configuration
Primary
connector
Master - hard disk
Slave - none
Master - hard disk
Slave - none
Master - hard disk
Slave - none
Master - hard disk
Slave - none
Master - hard disk
Slave - none
Master - hard disk
Slave - none
Master - hard disk
Slave - hard disk
Master - hard disk
Slave - hard disk
Master - hard disk
Slave - hard disk
Option Installation
check all configuration settings for
secondary connector
Master - none
Slave - none
Master - CD-ROM
Slave - none
Master - tape backup
Slave - none
Master - Zip drive
Slave - none
Master - CD-ROM
Slave - Zip drive
Master - CD-ROM
Slave - tape backup
Master - CD-ROM
Slave - none
Master - tape backup
Slave - none
Master - Zip drive
Slave - none
3-23