Replacing an AGP Video Board
To replace an AGP video board option in your system, use the following steps.
1.
Remove the system unit cover (see "Removing the System Unit Cover").
2.
If replacing an existing AGP video board, remove it according to the instructions
in the section above.
3.
If installing an AGP video board for the first time, remove the screw on the rear
of the chassis.
Carefully install the video board in the AGP slot and secure the board with the
4.
screw (see Figure 3-15).
5.
Replace the system unit cover (see "Replacing the System Unit Cover").
NOTE: If you are installing a PCI video board,
use the installation procedures for an expansion
board (see "Expansion Board Installation").
Figure 3-15 Installing an AGP Video Board
Option Installation
3-17