NEC PowerMate Enterprise Manual page 182

4-12 Maintenance and Troubleshooting
Problem
Keyboard or
mouse
malfunction
Monitor
malfunction
Table 4-2 Problems and Solutions
Symptom
Monitor has prompt, but
cannot input data.
Unable to synchronize
display.
Wavy display.
Blank display.
Solution
1.Check that keyboard/mouse is
plugged in.
2.Check password (see Section 2).
3.Disable password (see Section 2).
4.Replace keyboard (or mouse).
5.Replace system board.
1.Adjust the monitor's synchronization
controls.
2.Check that the monitor's resolution
matches the video setting or the video
driver used (see Section 1).
3.Check that the utility is not selecting
a refresh rate/resolution that is not
supported by the monitor.
4.Check that the driver used matches
the capabilities of the built-in video
controller and DRAM.
1.Check that the computer and
monitor are not near motors or electric
fields.
1.Press any key or move the mouse
to ensure power management has not
blanked the display.
2.Check that the monitor power
ON/OFF switch is ON.
3.Check that the monitor cable is
attached to the video connector at the
back of the system.
4.Check cable connections between
the AC power supply and monitor.
5.Adjust brightness and contrast
controls on the monitor.
6.Check cable connections between
the monitor connector and the system
board (or optional video board).
7.Replace system or video board.
8.Replace monitor.