Table of Contents
Advertisement
3-16
Option Installation
AGP VIDEO BOARD REMOVAL AND REPLACEMENT
The system board contains one accelerated graphics port (AGP) for installing AGP-
compatible graphics boards. The following sections describe how to remove and replace an
AGP graphics board in your system.
Removing an AGP Video Board
To remove an AGP video board option in your system, use the following steps.
1.
Remove the system unit cover (see "Removing the System Unit Cover").
2.
Remove the screw on the rear of the chassis and carefully lift the video board out
of the AGP slot on the system board (see Figure 3-14).
NOTE: If you are removing a PCI video board,
use the removal procedures for an expansion
board (see "Expansion Board Removal").
Figure 3-14 Removing an AGP Video Board
Advertisement
Table of Contents
Troubleshooting
