NEC PowerMate Enterprise Manual page 75

T
Plug the AC adapter into the DC IN jack on the back of the right speaker and
into a surge protector (recommended) or a properly grounded wall outlet.
T
Press the speaker power button on the rear of the right speaker. The power
lamp lights.
T
Adjust the controls on the front of the right speaker as required.
Connect the system to the network. If the network connector on the system board
5.
is being used, connect an RJ-45-compatible connector to it (see Figure 2-2). If a
network board is installed in the system, connect the network connector to the
network board. Depending on the type of board and the type of network
connection, the connector may look like one shown in Figure 2-8.
Figure 2-8 Network Connectors
Setup and Operation 2-7