Table of Contents
Advertisement
Option Installation
3-27
SCSI Signal Cable
SCSI configured systems come with an internal four-connector SCSI signal cable attached
to the internal 68-pin connector on the SCSI adapter board and to the installed SCSI hard
disk drive. Up to two additional SCSI devices can be attached to the connectors on the
cable.
If the SCSI cable is not keyed with a connector tab, align the colored edge of the cable with
the pin 1 side of the drive connector. Figure 3-22 shows the SCSI signal cable.
Figure 3-22 SCSI Signal Cable Connectors
Advertisement
Table of Contents
Troubleshooting
