3-30
Option Installation
Cabling a Diskette Drive
Cable a diskette drive as follows.
See "Device Preparation" in this section for preinstallation instructions.
1.
2.
Unplug the standard two-connector signal cable from the 1.44-MB diskette drive
and the diskette drive connector on the riser board. Remove the cable from the
system.
3.
Connect an optional three-connector diskette drive signal cable to the diskette
drive connector on the riser board and to the signal connector on the 1.44-MB
diskette drive (see Figure 3-25). Connect the drive to the end connector.
4.
Connect the middle connector on the signal cable to the optional diskette drive.
Locate an available power connector coming from the power supply (see "System
5.
Power Cables").
Connect the appropriate power cable to the power connector on the optional
6.
diskette drive.
Figure 3-25 Connecting 1.2-MB Diskette Drive Cables