Switch Board/Ir Panel Removal - NEC PowerMate Enterprise Manual

5-8 Repair

Switch Board/IR Panel Removal

The power, reset, and suspend switches, the power and disk lamps, and the IR port are all
located on the switch board/IR panel. A feature connector at the rear of the switch board/IR
panel carries signal and power for each these functions through a single cable to the riser
board.
Use the following steps to remove the switch board/IR panel:
1. Remove the system unit cover and front panel as previously described.
2. Locate the feature connector on the back of the switch board/IR panel. The
connector is accessed from the interior of the chassis, through a cutout in the
chassis wall.
Unplug the cable from the feature connector.
Remove the screws from the front of the switch board/IR panel.
3.
4. Remove the switch board/IR panel.
Figure 5-6 Locating the Switch Board/IR Panel