ZIP DRIVE JUMPER SETTINGS
The three-position jumper block for the Zip drive is located on the rear of the drive. The
following description applies when the rear of the drive is viewed with the IDE connector to
the left of the jumper block, and the power connector to the right.
T
Drive 0 Select (Master Drive Select) — right two pin sets jumpered
T
Drive 1 Select (Slave Drive Select) — right-most pin set jumpered
T
Cable Sect Mode — all three pin sets jumpered.
TAPE BACKUP UNIT JUMPER SETTINGS
The three-position jumper block for the tape backup unit is located on the rear of the
device. Use the following settings to jumper the device:
T
Cable Select jumper
T
Master device (5,6)
Enabled, DS jumpered
Disabled, DS open (factory default)
T
Slave device (3,4)
Disabled, open (factory default)
Enabled, jumpered.
(1,2) Not used
Jumper Settings
B-7