Management Module; Hsv Controller Cabling - HP EVA P6000 User Manual

Figure 1 1 Fan module pulled out
1. Green—Fan normal operation LED
Table 6 Fan status indicators
Status indicator
On left—Green
On right—Amber

Management module

The HP P6000 Control Panelprovides a direct interface to the management module within each
controller. From the HP P6000 Control Panel you can display storage system status and configuration
information, shut down the storage system, and manage the password. For tasks to perform with
the HP P6000 Control Panel, see the HP P6000 Control Panel online help.
The HP P6000 Control Panel provides two levels of administrator access and an interface for
software updates to the management module. For additional details about the HP P6000 Control
Panel, see the HP P6000 Control Panel online help.

HSV controller cabling

All data cables and power cables attach to the rear of the controller. Adjacent to each data
connector is a two-colored link status indicator.
presented by these indicators.
NOTE: These indicators do not indicate whether there is communication on the link, only whether
the link can transmit and receive data.
The data connections are the interfaces to the disk drive enclosures, the other controller, and the
fabric. Fiber optic cables link the controllers to the fabric, and, if an expansion cabinet is part of
the configuration, link the expansion cabinet drive enclosures to the loops in the main cabinet.
Y-cables (Figure 12 (page
data port to act as two ports.
28 P6300/P6500 EVA hardware
Fault indicator
Solid green
Blinking
Off
On
Table 1 (page 25)
29)) are used to connect the P6500 EVA and enable each controller
2. Amber—Fan fault LED
Description
Normal operation.
Maintenance in progress.
Amber is on or blinking, or the enclosure is powered
down.
Fan failure. Green will be off. (Green and amber are
not on simultaneously except for a few seconds after
power-up.)
identifies the status conditions