Unit Identification (Uid) Button; Power On/Standby Button; Sas Cables; Controller Enclosure - HP EVA P6000 User Manual

Unit identification (UID) button

The unit identification (UID) button helps locate an enclosure and its components. When the UID
button is activated, the UID on the front and rear of the enclosure are illuminated.
NOTE: A remote session from the management utility can also illuminate the UID.
To turn on the UID light, press the UID button. The UID light on the front and the rear of the
enclosure will illuminate solid blue. (The UID on cascaded storage enclosures are not
illuminated.)
To turn off an illuminated UID light, press the UID button. The UID light on the front and the
rear of the enclosure will turn off.

Power on/standby button

The power on/standby button applies either full or partial power to the enclosure chassis.
To initially power on the enclosure, press and hold the on/standby button for a few seconds,
until the LEDs begin to illuminate.
To place an enclosure in standby, press and hold the on standby button for a few seconds,
until the on/standby LED changes to amber.
NOTE: System power to the disk enclosure does not completely shut off with the power on/standby
button. The standby position removes power from most of the electronics and components, but
portions of the power supply and some internal circuitry remain active. To completely remove
power from the system, disconnect all power cords from the device.

SAS cables

These disk enclosures use cables with mini-SAS connectors for connections to the controller and
cascaded disk enclosures.

Controller enclosure

For both the P6300 EVA and P6500 EVA, a single enclosure contains a management module and
two controllers. Two interconnected controllers ensure that the failure of a controller component
does not disable the system. One controller can fully support an entire system until the defective
controller, or controller component, is repaired. The controllers have an 8 Gb host port capability.
The P6300 and P6500 EVA controllers are available in FC, FC-iSCSI, and iSCSI/FCoE versions.
The controller models are HSV340 (for the P6300) and HSV360 (for the P6500).
Figure 1 (page 22)
of the controller enclosure with the bezel removed.
shows the bezel of the controller enclosure.Figure 2 (page 22) shows the front
Controller enclosure 21