HP EVA P6000 User Manual page 275

Table 31 iSCSI or iSCSI/FCoE module log messages (continued)
106593
#%d: QLIoctlDisable:
Re-initialize adapter failed
106803
#%d: QLIsrEventHandler: Link
down (%x)
106813
#%d: QLIsrEventHandler:
Unexpected async event (%x),
MB1=%x, MB2=%x, MB3=%x,
MB4=%x, MB5=%x, MB6=%x,
MB7=%x
106847
#%d: QLProcessResponseQueue:
Invalid EntryStatus %x, type
%x
106851
#%d: QLTimer: Heartbeat
failed
106853
#%d: QLTimer: Link error
count (0x%x) exceeded, link
down
106912
#%d: QLReserveLoopId: out
of loop Ids
106928
#%d: QLMarkDeviceOffline:
Device Id: %x marked
offline, cLinkDownTimeout =
%x, cPortDownRetryCount=%x
106948
#%d: QLSnsGetAllNext: Name
server login FAILED %x
107029
#%d: QLUpdateDeviceData: out
of slots in host database
107030
#%d: QLUpdateDeviceData: out
of slots in target database
107041
#%d: QLUpdateDeviceDatabase
0x%x: GET_ID failed %x
107056 #%d: QLUpdateDeviceDatabase
0x%x: out of slots in host
database
107078
#%d: QLUpdatePort 0x%x: out
of slots in host database
107984
#%d: QLWriteFlashDword:
Write fails at addr 0x%x
data 0x%x
108032
#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for
VP %d fatal error
108033
#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for
VP %d failed %x
108049
#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB failed
MB0 %x MB1 %x
FC Error FC processor failed to re-initialize in response to
an IOCTL disable request.
FC Error FC processor reported a link down condition.
FC Error FC processor reported an unexpected asynchronous
event. The mailbox registers provide status, event
code, and data related to the event.
FC Error FC controller reported an invalid Entry Status %x,
type %x.
FC Error FC controller failed to provide a heartbeat.
FC Error Driver has determined that the FC link is unreliable
and unusable due to the number of errors
encountered. The link has been taken down.
FC Error FC processor was unable to obtain the number of
loop IDs required. This failure occurs only when the
FC processor is running multi-ID firmware.
FC Error Driver was unable to re-establish connection to the
target within the timeout and retry counts, and is
therefore marking it offline.
FC Error FC processor is unable to log into the FC fabric
name server.
FC Error Driver's host (initiator) database is full.
FC Error Driver's target database is full.
FC Error Driver's host (initiator) database is full. Maximum
host database is 64.
FC Error Drivers host (initiator) database is full.
FC Error Driver was unable to re-establish connection to the
target within the timeout and retry counts, and is
therefore marking it offline.
FC Error FC controller failed a Flash write (address x data
x).
FC Error FC controller failed the Get VP Database command
(for virtual port %d).
FC Error FC controller failed the Get VP Database command
(for virtual port %d) with status x.
FC Error FC controller reported failure status for an Execute
IOCB (input/output control block) command.
275