Is The Power On/Standby Button Led Amber; Is The Power Supply Led Amber; Is The I/O Module Fault Led Amber - HP EVA P6000 User Manual

Is the power on/standby button LED amber?

Answer
No
Yes

Is the power supply LED amber?

Answers
No
Yes

Is the I/O module fault LED amber?

Answer
No
Yes
Possible Reasons
System functioning properly.
The power on/standby button has
not been pressed firmly or held
long enough.
The system midplane and/or
power button/LED assembly might
need to be replaced.
Possible Reasons
Both power cords not connected or
AC power is unavailable.
Power supply functioning properly.
This supply is not receiving AC
power, but the other supply is
receiving AC power.
NOTE: It is possible for one
power supply to show a green
status and the other supply to show
an amber status.
Power supply might not be inserted
properly, might have a damaged
connector, or might have failed.
Possible Reasons
Functioning properly.
The I/O module is locked.
The I/O module has failed.
Other fault condition exists.
Possible Solutions
No action required.
Firmly press the power on/standby
button and hold for approximately
three seconds.
Be sure that all components are fully
seated.
Contact an authorized service
provider for assistance.
Actions
Remove and inspect the AC power
cords from both power supplies and
reconnect them.
No action required.
Verify AC input power.
Be sure that the power supply is
undamaged and is fully seated.
Be sure that all pins on connectors
and components are straight.
Contact an authorized service
provider for assistance.
Possible Solutions
No action required.
Make sure that the I/O module is
seated properly by pressing the I/O
module firmly into its bay after the
handle has clicked in place.
CAUTION: Never remove an I/O
module from the chassis while the
status LED is green. Removing an
active I/O module can result in data
loss.
Contact an authorized service
provider for assistance.
Diagnostic steps 153