Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual page 191

Note
When resources of the same servers are shared due to a change in usage, ensure that [Resource release] is set for the L-Server they are
allocated to.
When the server resources are allocated to the L-Server for which [Resource release] is not configured, the server resources cannot be
shared.
Boot Location
Decide whether the physical location of servers to be allocated to the L-Server can be changed.
When unselecting the [Automatic (when powered off)] checkbox of [Resource release], the location will be [Fixed].
-
Fixed
Starts the L-Server on the same physical server that was operated last time.
-
Relocate at startup
Automatically selects the optimal physical server when the L-Server is started.
Even when [Physical server] is specified, the L-Server may operate on a separate physical server from the second time it is started.
Server Recovery
Specify the server redundancy to allocate to the L-Server. To enable redundancy, select the [HA] checkbox.
When selecting the [HA] checkbox, the [Use a low spec server] checkbox of [Spare server specs], and <Select> of [Spare server pool]
will be enabled.
Spare server specs
This section specifies the selection method of spare server.
When the [Use a low spec server] checkbox is selected, physical servers with models matching that in the L-Server definition are
selected as spare servers.
For details on how to select a spare server, refer to "17.1.1 L-Server High Availability" in the "Operation Guide CE".
Spare server pool
Select the spare server pool.
Clicking <Select> displays the [Select a Server Resource] dialog.
Specify the server pool that the physical server to use for automatic switchover is registered in.
When a problem occurs on the physical server, recovery is performed by automatically switching to another physical server in the
same resource pool that is operating normally.
For details on how to perform switchover a spare server, refer to "17.1.1 L-Server High Availability" in the "Operation Guide CE".
Alive monitoring
Configure alive monitoring as enabled or disabled.
Address pool (WWN / MAC)
Select an address pool.
Clicking <Select> displays the [Select an Address Resource] dialog.
Select [Automatic] or [Pool]. The default is [Automatic].
When selecting [Pool], select from the registered address pool.
Specify the virtual WWN obtained from the I/O Virtualization Option and the address pool of the registered MAC address.
Startup priority
With L-Servers, when performing batch power operations in a resource folder or a tenant, configure the priority for the L-Server.
Set a number between 1 and 256. Smaller values indicate higher priority. If omitted, "128" is set.
- 175 -