Submenu Sequences - Duerkopp Adler 910 Operating Instructions Manual

8.5.1

Submenu Sequences

24
Adjustment of thread tension
Via this menu item the thread tension
is adapted.
Input: 0 .. 250
Pretension
Via this menu item the pretension
is set.
Input: 0 .. 100
Sequence mode
Via this menu item the sequence mode is switched on
or off.
Input: 0 = OFF
1 = ON
Condition: At least one program must be available in
1./2./3... 8.
Current sequence
Here the currently set sequence is displayed.
A maximum of 8 sequences can be assigned.
1./ 2./ 3.... 8.
Under these sequences existing programs from
the control can be memorized.
Procedure:
Use the cursor key to move to the next free storage
location.
Press the "OK" key (display of all sewing programs
in alphabetical order).
Select the sewing program using the cursor key
and confirm your choice by pressing the "OK" key.
Note:
Up to 8 sewing programs can be assigned to each
of the 8 possible sequences.
The figure "1" after the
sequence means
that more than one
page is available!