Duerkopp Adler 910 Operating Instructions Manual page 35

STL: (Stitch length)
Stitch length within the seam course.
Input: 0 ... 127
Example: 20 = 2.0 mm
Fspg. (Thread tension)
Input: 0 ... 100 (standard = 50)
Total tension = approx. 1000g
Setting 50 = approx. 500g
FA: (Thread trimming)
Cut the thread after the end of the seam course or not.
Input: 0 = no cutting
1 = cutting
2 = Thread burning
–
Switch to the display of coordinates with the key "ð ".
With the keys "ï", "ð ", "ñ " and "ò " the individual sections of the
seam contour are fixed in steps of 0.5 mm.
By stepping the pedal forward and with the keys "ï", "ð ", "ñ " and
"ò " the individual seam sections can be fixed in steps of 1.0 mm.
–
Move to the second coordinate point 2 with the keys "ï", "ð ", "ñ "
, "ò " or by stepping the pedal forward and with the keys "ï", "ð
", "ñ " and "ò ".
–
Press the "OK" key.
The coordinate point is taken over.
The following screen appears again:
2
33
1