Duerkopp Adler 910 Operating Instructions Manual page 67

Error- Description
code
3301 Error control
3320 procedure / Test
- procedure / Step
3322 motor test procedure /
3330 Starting procedure /
- Sewing procedure /
3332 Winding procedure /
3340 Adjusting aids
3341
3350
-
3351
3353
3360
3361
3400
3401
3403
4301 Dongle missing
4302 Dongle empty
4304 Wrong dongle type
4307 Wrong machine class
4311 Error Format-ID
4312 Unknown dongle type
5101 NV-RAM empty
5104 Error NV-RAM
checksum
5301 Data contour
5302 administration
5303
5305
5306
5340
5900 Error sequences –
Invalid sequence
number
6151 Error input/output
-
6154
2
6351 Error I C
-
6354
Possible cause
Internal error
No dongle plugged in
No data saved on the
dongle
The dongle has not the
proper format for the
wished function
The dongle data is not
formatted for the cl. 910
- Dongle not formatted
properly
Dongle faulty
- Dongle not formatted
properly
- Dongle faulty
Control is brand new, no
data found
Control is for another
class, incompatible data
NV-SRAM faulty
Failure
Internal error
Internal error
Internal error
Control faulty
Troubleshooting
- Switch the sewing machine off
and on again
- Software update
- Contact the DA-Service staff
Connect the dongle to the control
Save the data on the dongle
- Use other dongle type
- Format dongle
- Use other dongle type
- Format dongle
- Format the dongle anew
- Use a new dongle
- Format the dongle anew
- Use a new dongle
Data will be reset to factory setting.
- Check via Multitest, if necessary
replace the control
Switch the sewing machine off
and on again
Data will be reset to factory setting.
Switch the sewing machine off
and on again
Eventually the sewing prog. is not
ok:
Reset the sewing prog. again.
Load the sewing prog. from the
dongle again.
- Switch the sewing machine off
and on again
- Software update
- Contact the DA-Service staff
Switch the sewing machine off
and on again
- Check control
- Software update
- Contact the DA-Service staff
1
65