8.6.3
Seam pattern sequences
8.6.3.1 Switching the sequence programming mode on or off
30
Changeover from seam pattern operations to the seam pattern
sequence operations
–
Press the function key "S" while the main menu is being displayed
in order to go to the sequence programming mode.
–
Start the editing by pressing the "OK" key.
–
Select any sequence by using the "ñ" key (1-25)
–
Confirm the selection with the "OK" key.
The seam pattern sequence operation is switched on.
–
Press the "ESC" key or the "ï" key.
The main menu for the seam pattern sequence operation will be
displayed
The sequence number and sequence items in the main menu will be
described at the end of this section.
0