7.8 Adjusting The Lifting Movement Of The Clamping Plate; Sewing Foot Pressure - Duerkopp Adler 910 Operating Instructions Manual

7.8 Adjusting the lifting movement of the clamping plate

7.9

Sewing foot pressure

16
3
The height of the opened clamping plate 1 can be adjusted via the
knurled-head screw 3.
–
Loosen the counter nut 2.
–
Turn the knurled-head screw 3.
turn to the right = clamping plate 1 opens a little
turn to the left = clamping plate 1 opens wider.
–
Tighten the counter nut 2.
The desired sewing foot pressure is adjusted by means of the
knurled-head screw 4.
ATTENTION !
The material must not be lifted by the needle movement.
The pressure should not be set too high.
–
Loosen the counter nut 5.
–
Higher sewing foot pressure = turn the knurled-head screw 4 in
clockwise direction.
–
Lower sewing foot pressure = turn the knurled-head screw 4
counter-clockwise.
–
Tighten the counter nut 5.
2
4
5
1