Duerkopp Adler 910 Operating Instructions Manual page 37

STL: (Stitch length)
Stitch length within the seam course.
Input:
Fspg. (Thread tension)
Input:
FA: (Thread trimming)
Cut the thread after the end of the seam course or not.
Input:
–
Switch to the display of coordinates with the key "ð ".
With the keys "ï", "ð ", "ñ " and "ò " the circular arcs of the seam
contour are fixed in steps of 0.5 mm.
By stepping the pedal forward and with the keys "ï", "ð ", "ñ " and
"ò " the individual seam sections can be fixed in steps of 1.0 mm.
–
Move to the first coordinate point 1 with the keys "ï", "ð ", "ñ " ,
"ò " or by stepping the pedal forward and with the keys "ï", "ð ",
"ñ " and "ò " and determine this as non-sewing line.
Note
Point 1 is the last point of the prior seam course.
–
Press the "OK" key.
–
Move to the second coordinate point 2 with the keys "ï", "ð ", "ñ "
, "ò " or by stepping the pedal forward and with the keys "ï", "ð
", "ñ " and "ò ".
–
Press the "OK" key.
0 ...
0 ... 100 (standard = 50)
0 = no cutting
1 = cutting
1
1
2
3
35