Clamping Plates; Parallelism; Clearance Of The Clamping Plates To The Cloth Support Plate - Duerkopp Adler 579 Service Instructions Manual

9. Clamping Plates

9.1 Parallelism

9.2 Clearance of the Clamping Plates to the Cloth Support Plate

1
2
3
4
Caution Risk of Injury!
Set the clamping plates only in the "Safe Stop" position or with the
machine turned off.
Rule and Control
Both clamping plates must be set so that the clearance between the
clamping plates 5 and the cloth support plate 6 is the same everywhere
(Dimension X1 = X2).
Set a clearance which is the same along the whole length.
Correction
Set pin 1.
–
Caution Risk of Injury!
Set the clamping plates only in the "Safe Stop" position or with the
machine turned off.
Rule and Control
The clearance of the clamping plates to the cloth support plate must be
1 mm along the whole length.
Correction
Screw screw 2 out.
–
Loosen screws 3 and 4 on the cylinder.
–
Move the cylinder.
–
Set the clearance at 1 mm.
–
Tighten screws 3 and 4.
–
5 6
3
15