EPSON Stylus Pro 3800/3800C/3850
4.4 Disassembly/Assembly Procedure (Group 2)
This section describes disassembly/assembly procedures required only for off-site
servicing.
4.4.1 Removing the PAPER FEED MECHANISM
4.4.1.1 ASF, ASSY.
1.
Remove the HOUSING, UPPER.
2.
Carry out step 1. to step 9. of
"4.3.3.15 BASE, ENCLOSURE"
the PAPER, GUIDE, LOWER, L and PAPER, GUIDE, LOWER, R.
3.
Remove the two screws that secure the left and right GUIDE, ROLLER, LDs, and
remove the two GUIDE, ROLLER, LDs.
Two (one for each) C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
When removing/installing the screw that secures the GUIDE,
ROLLER, LD on the left side, use a screwdriver with a 100 mm or
shorter shaft.
4.
Lift up the two GUIDE, ROLLER, LDs on the rear side of the main unit to
disengage the hook and the tab, and remove the GUIDE, ROLLER, LDs.
Figure 4-122.
DISASSEMBLY & ASSEMBLY
(p106)
(p110), and remove
See Figure 4-121.
Disassembly/Assembly Procedure (Group 2)
Front side of the printer
Figure 4-121. Screws, hooks and tabs that secure the GUIDE, ROLLER, LD
Rear side of the printer
See
Figure 4-122. Removing the GUIDE, ROLLER, LDs
C.B.S. 3x6
GUIDE, ROLLER, LDs
Revision A
hook
tab
179