Epson 3800 - Stylus Pro Color Inkjet Printer Service Manual page 127

EPSON Stylus Pro 3800/3800C/3850
4.3.6.3 RELEASE SENSOR
1. Remove the HOUSING, UPPER.
2. Manually turn the SPUR GEAR, 22 shown in
FLAG, DETECTOR, RELEASE goes out of the detection part of the RELEASE
SENSOR (put the sensor into not-detecting state).
3. Disconnect the connector from the RELEASE SENSOR.
4. Release the four hooks that secure the RELEASE SENSOR, and remove the
RELEASE SENSOR. See Figure 4-50.
If the cables have come off the cable guides on the main unit while
removing the RELEASE SENSOR, be sure to route the cables
correctly referring to
DISASSEMBLY & ASSEMBLY
(p106)
Figure 4-50 clockwise until the
See Figure 4-50.
Figure 4-50.
Disassembly/Assembly Procedure (Group 1)
Route through cable guides
connector
Detected
RELEASE SENSOR FLAG, DETECTOR, RELEASE
Figure 4-50. Removing the RELEASE SENSOR
Revision A
SPUR GEAR, 22
RELEASE SENSOR
hooks
Not Detected
127