Epson 3800 - Stylus Pro Color Inkjet Printer Service Manual page 175

EPSON Stylus Pro 3800/3800C/3850
4.3.11.5 BELT, CR
1. Remove the CARRIAGE, ASSY.
2. Remove the BELT, CR from the belt holding part on the rear side of the
CARRIAGE, ASSY.
Make sure to check the following points when installing the BELT, CR.
„
Set the BELT, CR so that its lumpy side faces inward.
„
Put the both-sides-lumpy part of the BELT, CR into the belt
holding part of the CARRIAGE ASSY.
Inner side: lumpy
Outer side: flat
DISASSEMBLY & ASSEMBLY
(p169)
Inner side: lumpy
Both-sides-
Outer side: flat
lumpy part
Belt holding part
Disassembly/Assembly Procedure (Group 1)
Rear side
Figure 4-117. Removing the BELT, CR
Revision A
BELT, CR
CARRIAGE, ASSY.
175