Esc 3 N (Setting Line Feed Rate Of Minimum Pitch) - Citizen CT-S2000 Command Reference Manual

Line thermal printer
Hide thumbs Also See for CT-S2000:
Table of Contents

Advertisement

ESC 3 n
[Function]
[Code]
[Range]
[Outline]
[Caution]
[Default]
[See Also]
Setting line feed rate of minimum pitch
<1B>H<33>H<n>
0≤n≤255
Sets the line feed width per line to [n  b asic calculation pitch] inches.
• The line feed width can be set separately for the STANDARD and PAGE MODES.
• The basic calculation pitch is set by GS P. Once defined, the line feed width is not
changed if the basic calculation pitch is changed by GS P.
• Fractions resulting from calculation are corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
• In STANDARD MODE, this command uses the vertical (paper feed direction) basic
calculation pitch (y).
• In PAGE MODE, this command acts differently depending on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command uses
the vertical (paper feed direction) basic calculation pitch (y).
(2) If the start point specified by ESC T is top right or bottom left, the command uses
the horizontal (perpendicular to the paper feed direction) basic calculation pitch
(x).
• The maximum settable line feed width is 1016 mm (40 inches). A setting greater
than this maximum is trimmed to the maximum.
(1) When memory switch 5-2 is OFF:
Approx. 4.23mm
(2) When memory switch 5-2 is ON:
Approx. 3.75 mm
ESC 2, GS P
- 46 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents