Esc L (Selecting - Citizen CT-S2000 Command Reference Manual

ESC L
[Function]
[Code]
[Outline]
[Caution]
[See Also]
Selecting PAGE MODE
<1B>H<4C>H
Switches from STANDARD MODE to PAGE MODE.
• This command is only effective if it entered at the beginning of a line.
• This command is not effective if it is entered when in PAGE MODE.
• STANDARD MODE is restored when printing specified by FF is finished or when ESC S
is issued.
• The character mapping start position will be the point specified by ESC T in the print
area specified by ESC W.
• The commands listed below, which have separate settings for PAGE MODE and
STANDARD MODE, are changed to the settings for PAGE MODE use.
(1) Spacing setting:
(2) Line feed width setting:
• The following commands are valid only in PAGE MODE.
(1) ESC V Specifying/canceling 90°-right-turned characters.
(2) ESC a Aligning the characters.
(3) ESC { Specifying/canceling the inverted characters.
(4) GS L Setting the left margin.
(5) G3S W Setting the print area width.
• The following commands are disabled in PAGE MODE.
(1) GS ( A Executes test printing.
(2) FS p Prints NV memory bit image.
(3) FS q Defines NV memory bit image.
(4) GS v 0 Prints raster bit image.
• ESC @ restores STANDARD MODE.
Appendix 4.1.4 "Example of using PAGE MODE"
FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS W, GS
ESC SP, FS S
ESC 2, ESC 3
- 143 -