Citizen CT-S2000 Command Reference Manual page 188

MSW7-2： Data length
[Outline] Select the data length, which is a serial interface communication condition.
Enabled if DSW1-1 OFF is set [following memory switch setting].
[Default] 8 bits
MSW7-3： Stop bit
[Outline] Select the stop bit, which is a serial interface communication condition.
Enabled if DSW1-1 OFF is set [following memory switch setting].
[Default] 1 bit
MSW7-4： Parity
[Outline] Select the parity, which is a serial interface communication condition.
Enabled if DSW1-1 OFF is set [following memory switch setting].
[Default] None
MSW7-5： Busy control
[Outline] Select the busy control, which is a serial interface communication condition.
Enabled if DSW1-1 OFF is set [following memory switch setting].
[Default] DTR/DSR
MSW7-6: DMA control
[Outline] Select the enable/disable of DMA (Direct Memory Access) control.
[Default] Valid
Data Length
Stop Bit
Parity
Flow Control
DMA control
Setting Value
7 bits, 8 bits
Setting Value
1 Bit, 2 Bits
Setting Value
NONE, ODD, EVEN
Setting Value
DTR/DSR, XON/XOFF
Setting Value
Valid, Invalid
- 186 -