Gs A N (Enabling/Disabling Asb) - Citizen CT-S2000 Command Reference Manual

GS a n
[Function]
[Code]
[Range]
[Outline]
[Caution]
Enabling/disabling ASB (Automatic Status Back)
<1D>H<61>H<n>
0≤n≤255
This command selects the status item to be addressed by ASB
(Automatic Status Back.)
Bit Status Item Addressed by ASB
Status of pin 3 of drawer kick-out connector = Disabled
0
Status of pin 3 of drawer kick-out connector = Enabled
1 Online/offline status = Disabled
Online/offline status = Enabled
Error status = Disabled
2
Error status = Enabled
Continuous Paper Sensor = Disabled
3
Continuous Paper Sensor = Enabled
4 Undefined
5 Undefined
6 Undefined
7 Undefined
• If any status item is enabled, the status is sent to the host when this command is
executed. After that time on, the status is sent each time an enabled status item
changes. Because each status item represents the current condition, status items
disabled for ASB may also have changed.
• The ASB function is disabled if all status items are disabled.
• If the ASB function is enabled by default, the host receives the status the first time
the printer gets ready for communication after it is turned on.
• The printer sends 4 bytes of status shown in the tables below, without checking
whether the host is ready to receive or busy. The 4 bytes of status is a continuous
string except for XOFF code.
• Because this command is executed when data is mapped in the receive buffer, there
may be a delay between command receiving and status sending depending on the
condition of the receive buffer.
• Even if the printer is excluded from the selection of peripheral equipment ESC =, the
4 bytes of status is sent to the host whenever status changes.
• When DLE EOT, GS I, or GS r is used, the host must discriminate between the status
specified by these commands and the status due to ASB.
- 59 -
Hex. Decimal
00 0
01 1
00 0
02 2
00 0
04 4
00 0
08 8
— —
— —
— —
— —