Esc A N (Aligning The Characters) - Citizen CT-S2000 Command Reference Manual

ESC a n
[Function]
[Code]
[Range]
[Outline]
[Caution]
[Default]
[Sample Program]
[Print Results]
Aligning the characters
<1B>H<61>H<n>
0≤n≤2
48≤n≤50
All the printed data within one line are aligned in the specified position.
Depending on the value "n", positional alignment is carried out as shown in the table
below:
n
0, 48 Left end alignment
1, 49 Centering
2, 50 Right end alignment
• This command is valid only when it is inputted at the beginning of a line.
• This command does not affect the PAGE MODE.
• Executes justification in the print area being set.
n = 0
LPRINT CHR$(&H1B);"a"; CHR$(0);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(1);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(2);
LPRINT "AAAAA"; CHR$(&HA);
AAAAA
AAAAA
Left-justified Centered
Position
Paper feed direction
AAAAA
Right-justified
- 39 -