Msw3 - Citizen CT-S2000 Command Reference Manual

MSW2-6： Reserved [Fixed to OFF (0)]
MSW2-7： Reserved [Fixed to OFF (0)]
MSW2-8： PNE sensor
[Outline] Select paper near-end enable/disable.
ON (1) OPERATION: Disable paper near-end
OFF (0) OPERATION: Enable paper near-end
[Default] OFF (0) [Valid]

MSW3

MSW3-1： Auto-cutter return
[Outline] Select return method from cutter lock error.
ON (1) OPERATION: Return by command.
OFF (0) OPERATION: Return with FEED switch.
[Default] OFF (0) [Valid]
MSW3-2： Reserved [Fixed to OFF (0)]
MSW3-3： Parallel 31 pin
[Outline] Printer can be reset by parallel I/F –31 Pin signal. Select the handling of this signal.
ON (1) OPERATION: Used as reset signal
OFF (0) OPERATION: Not used as reset signal
[Default] OFF (0) [Valid]
* Parallel I/F specification only enabled.
MSW3-4： Reserved [Fixed to OFF (0)]
MSW3-5： Reserved [Fixed to OFF (0)]
MSW3-6： Reserved [Fixed to OFF (0)]
PNE Sensor
Resum Cttr Err
After removing error cause, return with command <DLE ENQ n>.
After removing error cause, return by long pressing FEED SW (1 sec or longer).
Parallel 31 pin
OFF (0)
Valid
OFF (0)
Valid
OFF (0)
Valid
- 182 -
ON (1)
Invalid
ON (1)
Invalid
ON (1)
Invalid