Removing The Holding Tray From The Copier; Removing The Holding Tray Re-Pick Up Assembly - Canon NP6251 Service Manual

CHAPTER 5 PICK-UP/FEEDING SYSTEM

2. Removing the Holding Tray from the Copier

1) Open the front cover.
2) Remove the fixing/feeding front cover.
3) Slide the holding tray assembly to the front and out of the copier.

3. Removing the Holding Tray Re-Pick Up Assembly

1) Slide the holding tray assembly to the front and out of the copier.
2) Remove the screw
and the inlet assembly rear cover
the two connectors
3) Remove the three mounting screws
5-102
COPYRIGHT © 1997 CANON INC.
(1 each), and remove the inlet assembly front upper cover
; then, remove the two screws
to remove the sided guide plate
Figure 5-872
(front).
Figure 5-873 (front)
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
and disconnect
.