Canon NP6251 Service Manual page 506

9) Set the mode of control.
9-1) Set the mode of control using the Ten Key Pad-A1.
Press /
9-2) According to the type of copier and the specifications of the user, set the mode of
control as indicated. (The default is '1'.)
9-3) To select '3' as the mode of control, for example,
1. The display shows
Press the
A press on the
A press on the
2. When the display shows
3. The display shows
formatting is under way. Then, the cursor stops flashing to indicate that '3' has
been selected for the mode of control.
Note:
Setting a new mode of control clears such data as the unit price, upper limit, counter
reading, and ID. Set them again as necessary.
COPYRIGHT © 1997 CANON INC.
until the display shows
No. No. of groups
1 3000
2 1000
3 1000
. Since the default is '1', change it to '3'.
FORMAT=1
key.
key clears the input, allowing you to try again.
key cancels the operation.
ESC
FORMAT=3_
FORMAT=3_
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
.
FORMAT=1
Paper size
5
5 one-sided/two-sided
5 mono/2-color/full-color
Table 9-505
, press the
ENT
, and the cursor flashes for a while to indicate that
CHAPTER 9 INSTALLATION
Mode
—
key.
9-51