Replacing The Delivery Roller Leaf Spring; Assembly - Canon NP6251 Service Manual

Hide thumbs Also See for NP6251:

Table of Contents

2. Replacing the Delivery Roller Leaf Spring

When removing the stapler sorter or the sorter from the machine (i.e., to use the copy

tray), you must replace the two leaf springs of the delivery roller with leaf springs (weaker

spring pressure) identified with a blue label.

When installing a stapler sorter or a sorter to the machine, check to find out if the two

leaf springs at the center are stronger than the two leaf springs on the sides; if so, do not

perform the steps that follow.

Remove the two screws, and remove

the cover from the fixing/delivery

Remove the screw, and remove the

two leaf springs (w/ rolls) at the center;

then, separate the leaf springs and the

Fit the roll to the leaf spring that comes

with the machine, and install the leaf

spring to the fixing/delivery assembly.

Install the cover to the fixing/delivery

assembly (2 screws), and slide in the

fixing/delivery assembly into the

machine, and close the front door.

CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)

CHAPTER 9 INSTALLATION

Table of Contents