Checking The Developing Assembly - Canon NP6251 Service Manual

CHAPTER 9 INSTALLATION
F. Checking the Developing Assembly
Step
1 Open the multifeeder tray.
Open the multifeeder door, and
remove the screw from the door
tape.
2 Remove the screw, and slide the
developing assembly locking unit in
the direction of the arrow (rear) to
remove.
3 Take the developing assembly out of
the shipping box. Check the surface
of the cylinder for scratches while
turning the developing cylinder gear
by hand.
4 Holding the center (grip pocket) of
the developing assembly, install it to
the machine.
Connect the connector.
Caution:
When installing the developing
assembly, insert it from above so
that the developing cylinder will
not come into contact with the
metal plate of the developing
assembly mount.
9-18
COPYRIGHT © 1997 CANON INC.
Work
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Screw
Connector
Screw