Removing The Lifter Cable (Deck Front) - Canon NP6251 Service Manual

Hide thumbs Also See for NP6251:

Table of Contents

CHAPTER 8 PAPER DECK-A1

5. Removing the Lifter Cable (deck front)

1) Open the compartment of the deck; remove all copy paper, if any.

2) Remove the screw, and remove the trailing edge guide plate from inside the

compartment.

3) Push the sensor lever

finger to lower the lifter until the holes (left-right) in the compartment side plate and

the holes (left/right) in the lifter match; then, insert two screwdrivers (to position the

4) Remove the front cover of the deck. (See p. 8-21.)

5) Remove the four screws

of the paper supply sensor inside the compartment with a

Figure 8-406

, and remove the roll support plate

Figure 8-407

CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)

Table of Contents