Routing The Lifter Cable - Canon NP6251 Service Manual

7. Routing the Lifter Cable

1) Check to make sure that the lifter drive shaft and the lifter are held in place with hex
wrenches and screwdrivers. (
2) Fix the cable fixing plate in place on the lifter with two screws. (
3) Hook the lifter cable on the pulley. (
4) Hook the ball of the lifter cable on the lifter drive shaft; then, wind it about 1.5 times
along the groove of the pulley. At this time, be sure that the lifter cable is taut until
the drivers have been lifted until they stop. (
5) While keeping the spatial relationship, fix the pulley in place to the lifter drive shaft
with two set screws. (
6) After fixing all pulleys that have been removed to the lifter drive shaft, measure the
distance (height) from the base plate of the compartment to the top face of the lifter
to check that the lifter is level.
COPYRIGHT © 1997 CANON INC.
an of Figure 8-413)
of Figure 8-413)
of Figure 8-413)
Figure 8-413
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 PAPER DECK-A1
of Figure 8-413)
(rear)
of Figure 8-413)
8-43