Canon NP6251 Service Manual page 504

7) Push the switch (SW2) on the Copy Data Controller-A1 to enter service mode.
8) Set the mode of input as follows:
8-1) Select card or ID input using the Ten Key Pad-A1. (The default is card input.)
8-2) To change from card input to ID input, operate as follows:
To change from ID to card* input, go to step 8-4).
*You will need a Card Reader-A1.
MANAGE=CARD
8-3) Press the key, and press the
The display will show
8-4) To change to card input, press the
press the
ENT
The display will show
Note:
1. Setting the DIP switch (SW5-4) on the Copy Data Controller-A1 to OFF de-
selects group control, and the display will be as follows:
2. If ID mode has been stored in the copier's memory, you can use that ID for the
Copy Data Controller-A1. To do so, operate as follows:
COPYRIGHT © 1997 CANON INC.
SW2
LED1 LED2 LED3
LED4 LED5 LED6
JC5
CPU
J5
6 1 6
SW1 ON SW5 ON
Fig. 9-516
appears.
ENT
.
MANAGE=ID
key.
MANAGE=CARD
Code
1
2
Table 9-502
Fig. 9-517
CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
SW2
SW3
JC8
JB2
JC6 JB1
JC9
IPC
SW4
1
key.
key when the display shows
.
Input mode
Card
ID
CHAPTER 9 INSTALLATION
JA1
JA2
MANAGE=ID
; then,
9-49