Table of Contents
Advertisement
8. When prompted, do not restart the RSA adapter. You will do this after loading
the second firmware PKT file.
9. Repeat the steps for the second PKT file.
10.Restart the adapter by selecting ASM Control → ASM Restart.
11.After the RSA II is restarted, select Monitors → Vital Product Data to verify
that the new code is applied. This is reported in the RSA II event log.
6.2.6 Implementing the RSA II in the operating system
The device drivers provide operating support and in-band communication with
IBM Director. This section describes how to install the RSA II device driver on
Windows and Linux platforms. The required device drivers are listed in Table 6-1
on page 308
After you install the operating system, also install the driver or service for the
RSA II SlimLine adapter.
Download the RSA II device driver
Download one of the following drivers:
RSA II service for 32-bit Windows Server 2003 and Windows Server 2008
http://www.ibm.com/support/docview.wss?uid=psg1MIGR-5071025
RSA II service for x64 Windows Server 2003 and Windows Server 2008
http://www.ibm.com/support/docview.wss?uid=psg1MIGR-5071027
RSA II daemon for Linux (RHEL 3 and 4, SLES 9 and 10, ESX 3)
http://www.ibm.com/support/docview.wss?uid=psg1MIGR-5071676
Windows service installation
The installation of the RSA II server software package is unlike the driver
installations of older systems management adapters. It is done by executing the
downloaded executable file.
To install the RSA II device driver on the Windows service:
1. Execute the downloaded EXE file on the server with the RSA II.
2. Optionally, click Change to specify an alternate temporary folder for the
installation files.
The installation process starts automatically after the files are copied.
3. Follow the instructions.
Chapter 6. Management
329
Advertisement
Table of Contents
