Table of Contents
Advertisement
– ESX Server 3i Configuration Guide
http://www.vmware.com/pdf/vi3_35/esx_3i_e/r35/vi3_35_25_3i_server
_config.pdf
Configure server BIOS for Embedded Hypervisor Boot
To configure the server's BIOS:
1. Press F1 to boot the server in the BIOS.
2. Go to Start Options → USB Disk and set it to Enabled, as shown in
Figure 5-11.
Figure 5-11 Example of x3850 M2 BIOS Start Options with USB Disk enabled
3. In Start Options → Startup Sequence Options, set the following startup
sequences to IBM Embedded Hypervisor, also shown in Figure 5-12 on
page 266:
– Primary Startup Sequence: Third Startup Device
– Wake on LAN® Startup Sequence: Fourth Startup Device
265
Chapter 5. Installation
Advertisement
Table of Contents
