Table of Contents
Advertisement
Click Custom Configuration. In the Physical Drives panel, shown in
Figure 3-73, define the number of disks that you want to add to a virtual disk
to assign to a disk group.
Figure 3-73 WebBIOS: Configuration Wizard custom DG definition (on left)
You can assign all available disks that have the status of Unconfigured good
to different disk groups as follow:
a. Select the disk in the panel view.
b. Click AddtoArray to assign to a disk group. Repeat this step to add more
disks.
TIp: You can assign multiple disks at the same time if you press the
Shift key and use the Up and Down arrow keys to select the disks, can
then click AddtoArray.
c. Confirm this disk group by clicking on the Accept DG button, shown in
Figure 3-74 on page 184. The WebBIOS increases the disk groups and
allows you to assign more disks. Repeat this step if you want another disk
group.
d. If you want to undo a drive addition, click the Reclaim button.
Chapter 3. Hardware configuration
183
Advertisement
Table of Contents
