Table of Contents
Advertisement
Standalone Boot buttons are shown in Figure 4-20.
Figure 4-20 RSA II Web interface: Standalone Boot buttons
The Standalone Boot buttons can either force a partition out of stand-alone
mode, or put back in stand-alone mode, as follows:
– Stand-alone mode
The Force button resets a multinode system and boots a selected system
in stand-alone mode. First select the PID of the partition you want to
control, and then click Force.
Notes:
• The stand-alone mode allows the systems to boot separately for
• If the system is in this mode already, the command is ignored.
– Multinode mode
A system in a partition that is started in stand-alone mode can be
reassigned to boot in the multinode mode again. Select the SN (serial
number), then click Undo.
Notes:
• One or more systems that are members in a partition and booted in
• If the system is in multinode mode already, this command is ignored.
Partitions Configure buttons are shown in Figure 4-21.
Figure 4-21 RSA II Web interface: Partition Configure buttons (create partitions)
222
Planning, Installing, and Managing the IBM System x3950 M2
debugging or diagnostic purposes.
stand-alone boot, swap back to the boot mode multinode.
Advertisement
Table of Contents
