Table of Contents
Advertisement
6. Default partitions are provided by the ESX 3.5 Update 1 installer. You can
change the default partition layout if required, as shown in Figure 5-31.
Otherwise, accept the defaults and click Next to continue.
Figure 5-31 Choosing the Partition Layout for ESX 3.5 Update 1.
The default boot loader setting from VMware ESX 3.5 Update 1 installer
configures the boot loader to be installed on the MBR of the disk, which you
selected earlier, on which to install VMware ESX 3.5 Update 1.
7. Network Configuration enables you to select the available Network Adapters
to use for the default vSwitch and vSwif0 interface for shared Virtual Machine
and Service Console access. You may modify the physical Network Adapter
that is configured for the vSwitch and the vSwif interface.
8. Select the time zone as appropriate to your location.
9. Under Account Configuration, you may configure the Root Password and add
new users to the ESX 3.5 Udpate 1 system.
10.In the summary window of all the selections you have made during the
installation process, confirm the selections and click Next to begin the
installation.
284
Planning, Installing, and Managing the IBM System x3950 M2
Advertisement
Table of Contents
