Table of Contents
Advertisement
Devices and I/O Ports
Serial Port A
Remote Console Redirection
Mouse
Planar Ethernet
Planar SAS
High Precision Event Timer (HPET)
Video
IDE Configuration Menu
System MAC Addresses
Figure 3-42 BIOS: system devices and ports
Decide which controller you want to boot the server from and select it in the PCI
Device Boot Priority field in Start Options menu, Figure 3-43.
Startup Sequence Options
Planar Ethernet PXE/DHCP
PCI Device Boot Priority
Keyboard NumLock State
USB Disk
Boot on POST/BIOS Error
Boot Fail Count
Rehook INT 19h
Virus Detection
Figure 3-43 BIOS: Start Options
Note: If you have to change BIOS settings on secondary nodes in a multinode
complex, you must first break the partition and boot the nodes into standalone
mode. You can then change the BIOS settings as required.
Power on your server. Watch the window in POST. Press Ctrl+C while the
messages in Figure 3-44 on page 156 are shown.
[ Port 3F8, IRQ4
[ Installed
[ Enabled
[
Enabled
[ Enabled
Start Options
[ Planar Ethernet 1
[
Planar SAS
[ Off
[ Enabled
[ Enabled
[ Disabled
[ Disabled
[ Disabled
Chapter 3. Hardware configuration
]
]
]
]
]
]
]
]
]
]
]
]
]
155
Advertisement
Table of Contents
