Table of Contents
Advertisement
The Manage Partition(s) option lists a variety of functions in the Scalable
Complex Management panel, shown in Figure 4-18 on page 220. The following
buttons enable you to configure, monitor, and manage scalability partitions:
Partition Control buttons are shown in Figure 4-19.
Figure 4-19 RSA II Web interface: Partition Control buttons
The buttons provide the following functions:
– Start partition
The Start button powers on a system or partition. To start a partition,
select the serial number (SN) or a partition ID (PID) check box, and then
click Start.
Notes:
• Single systems behave as a partition of one.
• Multiple systems and partitions can be controlled at the same time.
• If the systems are in a partition, the partitions must be shut down first to
make sure that these will merge.
– Reset partition
The Reset button reboots a system or partition that is currently
powered on. If the system is off, the command is ignored. To reset the
partition, select the SN or a PID check box, then click Reset.
Notes:
• Single systems behave as a partition of one.
• Multiple systems and partitions can be controlled at the same time.
– Stop partition
The Stop button shuts down a system or partition that is currently
powered on. If the system is off, the command is ignored. To stop a
partition, select the SN or a PID check box, and click Stop.
Notes:
• Single systems behave as a partition of one.
• Multiple systems and partitions can be controlled at the same time.
Chapter 4. Multinode hardware configurations
221
Advertisement
Table of Contents
