Installing Memory-Module Kits - IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual

10. Install the two-drop SCSI cable:
11. To install an IDE device, such as a CD-ROM or a DVD-ROM, use the
12. Connect a power cable to the back of the drive. Power cables for
13. If you are installing another 5.25-inch drive, do so now. Otherwise, continue
14. Connect the shuttle.
15. If you have other options to install or remove, do so now; otherwise, go to

Installing memory-module kits

Note: The illustrations in this document might differ slightly from your hardware.
Before you continue with the memory-installation procedure, review the following:
v Review the information in "Before you begin" on page 43.
54
Hardware Maintenance Manual: Netfinity 7100 – Type 8666
Note: Slide rails for installing a tape drive are attached with screws. Use the
screws to attach the rails to the side of the tape drive.
7. Align the slide rails on the drive with the guide rails in the bay; then, slide
the drive into the bay until it snaps into place.
Note: If you are installing a tape drive, use the screws that are shipped next
to the tape drive rails to attach the tape drive to the front of the chassis.
8. Disconnect the shuttle (see "Disconnecting the shuttle" on page 110).
9. If you are installing a SCSI device, go to step 10. If you are installing an IDE
device, go to step 11.
a. Disconnect the SCSI cable from the SCSI connector on the power
backplane.
Note: If you disconnect the SCSI cable from the hard disk drive backplane,
the server will not support a drive in a hot-swap bay. You can
obtain an optional SCSI adapter to control the SCSI hot-swap
backplane.
b. Locate the two-drop SCSI cable. The two-drop SCSI cable comes with your
server and is located in the bottom of your server between the open bays
and the power supply area. It is folded and restrained with a cable clamp.
c. Connect one of the connectors on the two-drop SCSI cable to the back of
the drive.
d. Go to step 12.
two-drop IDE cable that comes with the option.
a. Remove the cable that connects the CD-ROM to the IDE connector on the
power backplane.
b. Use the two-drop cable that came with the IDE option to connect the
CD-ROM and IDE device you are installing to the IDE connector on the
power backplane.
c. Set the jumper on the back of the new IDE option to secondary.
removable-media drives come installed in the server. The connectors are keyed
and can be inserted only one way.
with step 14.
a. Disengage the retaining levers from the notches on the chassis.
b. Move the retaining levers toward the front of the server.
c. Secure the retaining levers in the horizontal position.
"Completing the installation" on page 62.